Guide d'installation

Ce guide vous aide à préparer l'installation d'un Quooker avant de commander. Il ne remplace pas le manuel d'installation officiel fourni avec le produit.

Avant de commander

Vérifiez l'espace sous l'évier pour le réservoir et le module CUBE optionnel.
Confirmez l'accès aux points d'eau, d'électricité et de drainage.
Choisissez le réservoir approprié : PRO3, COMBI ou COMBI+.
Vérifiez si des kits d'extension, des supports de montage ou des filtres sont nécessaires.
Gardez l'emballage intact jusqu'à ce que l'installation soit terminée.

Préparation recommandée

Si vous avez des doutes concernant l'espace dans le placard ou la compatibilité, demandez à votre installateur de vérifier la disposition avant de commander. C'est particulièrement important lors de la combinaison d'un robinet, d'un réservoir, d'un CUBE et de filtres.

Acheter des accessoires d'installation

Installation readiness

Every Quooker is installed by a qualified plumber. This checklist helps you confirm your kitchen is ready before the tap arrives, so installation stays a short, one-visit job.

Genuine Quooker

Sold and supported as a Quooker specialist.

Independent advice

We only sell Quooker, so every recommendation is on-topic.

Belgium install support

Crowntap install network in Belgium; EU-wide shipping and guidance.

Warranty guidance

Clear support on Quooker warranty coverage.

Before your Quooker arrives

Kitchen readiness checklist

Walk through these six checks before installation day so your plumber can finish the job in a single visit. Belgium: install support via our Crowntap network. Elsewhere in Europe: we ship the tap and support you through it — installation itself stays with your local plumber.

Qualified plumber

Professional installation recommended. Your plumber confirms the exact spec for your Quooker model.

Cabinet space

Enough clearance under the sink for the reservoir (and CUBE if included), with a small service gap on each side.

Grounded 230 V socket

Reliable 230 V connection inside the cabinet, on a circuit that can supply the reservoir continuously.

Cold-water connection

Mains cold-water supply with a shut-off valve so the reservoir can be isolated for service.

Worktop hole

Standard tap hole for the Quooker spout. Confirm the diameter with your plumber before drilling.

Ventilation and clearance

Small clearance around the reservoir and CUBE so heat can dissipate and units can be serviced later.

Keep exploring

Ready to order? Start here

Find the right Quooker in 60 seconds Starter packs — tap + PRO3 Comfort packs — tap + COMBI Comfort+ packs — tap + COMBI+Complete CUBE packs Full buying guide

FAQ

Frequently asked questions

Does Watertap.eu install the Quooker for me?Open

Hands-on installation is only available in Belgium via our Crowntap partner network. Outside Belgium we ship the Quooker across the EU via DHL Express and provide guidance and support — installation itself is arranged with your own qualified plumber.

How much cabinet space do I need?Open

You need enough clearance in the cabinet under the sink for the reservoir (and CUBE if included), plus a small service gap on every side for ventilation and future maintenance access. Exact dimensions depend on the model.

Do I need a specific power connection?Open

Yes. A grounded 230 V socket must be available in the cabinet under the sink, on a circuit that can supply the reservoir continuously.

What about the worktop hole and water connection?Open

The tap fits a standard tap hole in the worktop and connects to the mains cold-water supply via a shut-off valve. Your plumber will confirm the exact spec for your Quooker model.

Do I need ventilation around the reservoir or CUBE?Open

Yes — leave a small clearance on every side of the reservoir, and a bit more around the CUBE, so the units can dissipate heat and be serviced later without removing the sink.